Truesight Software Updates | Headsight Harvesting Solutions
  1. Home
  2. Truesight Software Updates

Truesight Software Updates

Instructions for how to upgrade to the new Truesight software are included in the downloaded zip file in PDF form.

Version - 2.40C

  • Release Notes 2.40C IMPORTANT - ONLY FOR ORIGINAL TRUESIGHT - NOT FOR TRUESIGHT 2
  • • Steering Wheel Disengage with Outback valve systems should now work
  • • Fixed an issue with John Deere steering wheel disengage when AgLeader steering is also installed on the machine.
  • *TS Bootloader 3.1

Version - 2.40B

  • Release Notes 2.40B
  • Truesight(2.40B) - IMPORTANT - ONLY FOR ORIGINAL TRUESIGHT - NOT FOR TRUESIGHT 2
  • • Highlighted the importance of the Speed Safety
  • o Disclaimer added when changing Speed Safety to “OFF”
  • o Added a Disclaimer to Run Screen every key cycle when Speed Safety is set to “OFF”
  • o Turn the Knob to the right to ‘Scroll’ through the disclaimer. Accept the disclaimer to dismiss it.
  • *TS Bootloader 3.1

Version - 2.40A

  • Truesight (2.40A)
  • IMPORTANT: This software is intended for original Truesight system only (Not Truesight 2)
  • - Fixed Ontrac2 steering wheel disengage.

Version - 2.40

  • Truesight (2.40)
  • IMPORTANT: This software is intended for original Truesight system only (Not Truesight 2)
  • - Version number updated

Version - 1.30

  • Add support for JD closed center hydraulic (CCH) systems
  • Add notifications for incomplete calibration
  • Add support for new remote display (HW1.2)
  • Add support for new base hardware (HW1.40)

Version 1.27

  • Fixed tilt sensor limited to 1.0V on Hardware V1.0

Version 1.26

  • Added support for Hardware V1.30

Version 1.25

  • Added support for Ontrac2 for Hardware V1.30
  • Minor bug fix

Version 1.24

  • Fixed an issue where EZ-Steer was hard to disengage Only in Version 1.2

Version 1.23

  • Fixed an issue with some Accuguide systems that would disengage by the steering wheel without steering wheel motion.
  • Fixed an issue with some Outback Edrive systems that would only do the Right side of the "Auto detect dead zone" calibration

Version 1.22

  • Fixed an issue with our latest controller and JD AutoTrac ready combines.  All customers with JD AutoTrac ready combines using our latest controller (shipped 6/1/10) should update to this version

Version 1.21

  • Added support for 2010 JD 70 series steering wheel encoders

Version 1.20 (Everyone should update to this version)

  • Added better support for curves
  • GPS speed is now standard
  • If your software version is older than 1.20, it is best to update to the current version
© Copyright Headsight Harvesting Solutions 2024